emzqrwriue 4 Stroke 6.5HP Outboard Boat Engine Boat Motor Water Cooling System

Buy 4 Stroke 6.5HP Outboard Boat Engine Boat Motor Water Cooling System

Description:

For four-stroke engine oil, please use gasoline of No. 92 or above, and add the oil to the internal fuel tank separately

Short axis:

Shaft length 381 mm (15 inches) （Type 1）

Suitable for ships with stern plate height below 44 cm (inclusive)

Long axis:

Shaft length 508 mm (20 inches) （Type 2）

Suitable for ships with a stern plate height of 45 cm (inclusive) ~ 55 cm (inclusive)

Specification:

Displacement	123CC
Transmission ratio	2.08 (27:13)
Number of cylinders	1
Full throttle perating range	5000-6000r/min
Maximum output	4.8kw
Type	4-stroke
Ignition system	CDI system
Starting system	Manual start
Contorl System	Tiller control
Gear positions	F-N-R
Recommended fuel	Regular #92 unleaded gasoline
Recommended  engine oil	four-stroke engine oil
Tilt tilt system	manual tilt
Standard fuel tank capacity	12L
Overall length	78.3CM
Overall widteh	34.3cm
Overall height	102.3cm
Bore x stoke	59*45
Recommended Propeller Size	3-7"x9"
Transom plate height	43.5cm

Announcements:

After in the sea water or turbid water cruising

1.Use the fresh water cleaning the outboard motor

2.With the moderate SPREED circulating the engine,cool off the water down with fresh water.

3.Before completely running out cooling water,don't put the outboard motor outside.

Otherwise the water cam pass the exhaust port to enter the 

air cylinder, from that will cause the engine breakdown.

4.The engine should deposit in the aridity and ventilated well place,avoid exposing directly in the sunshine.

5.Before the long term storing,you should run out of the gasoline in the fuel tank.

 

Note: 

Please add gear oil to the gears before use the motor and replace gear oil after the run-in period (10hours).

(if you do not know how to handle this, please contact with us )

 

Warning:

Cylinder Scoring is a serious damage,which caused by improper use and will cost you a lot of money to repair the motor.

Don't do the following will avoid cylinder Scoring:

1, start the motor on bank

2, use the motor when it stop coming out of water

Even if you want test the motor, it should be done in the river!

When there is no water coming out from the motor,please stop using it immediately ,

then check the impeller of Water pump or check if the water outlet has been blocked.

 

Package Included:

1 X	Boat Engine

4 Stroke 6.5HP Outboard Boat Engine Boat Motor Water Cooling SystemBuy Now